Receipt Printer Troubleshooting: Reconfigure IP Address

Receipt Printer Troubleshooting: Reconfigure IP Address

Overview

If your receipt printer is no longer printing, it may be because you need to reconfigure the IP address of the printer. To do so, please follow the below steps.

 

1. Make sure the printer is turned off and then hold down the Feed button, while pressing the power on until the self-test page prints.

2. When the page pauses, press again on the Feed button and then release.

3. A Main Menu will appear with options. Use the Ethernet Configuration option by pressing the Feed button 7 times and then holding.

4. When the Ethernet Configuration menu appears, use the Set DHCP option by pressing the Feed button 5 times and then holding.

  • It should then print "Interface is Configuring" and then pause for 45 seconds. 

5. When the DHCP menu appears, use the DHCP Enable option by pressing the Feed button 2 times and then holding.

6. In the next menu, use the Exit With Save option by pressing the Feed button 2 times and then holding.

  • It should print "Saving config, please wait....", followed by "Configurations have been saved, please repower the printer"

7. Perform another self-test by repeating Step 1. This time, it should pause in the middle and say "Configuring," while the printer searches for the IP address. It should then continue printing the self-test, including the located IP Address. 

8. In the Communication Interface section of the self-test, next to DHCP, it should now say "Enabled."

    • Related Articles

    • Receipt Printer Troubleshooting on Windows PC

      If you are using a supported eHopper printer and your receipt printer stops printing, please follow the below steps for troubleshooting.  1. Hold the Feed button on the printer. If nothing prints, that means their either is a paper jam or no paper in ...
    • Receipt Printer Troubleshooting

      Overview If your receipt printer is not printing, follow the troubleshooting steps below (for both Ethernet and Bluetooth printers).   Ethernet Receipt Printer Troubleshooting If using an ethernet connected receipt printer, follow the steps below.  ...
    • Configuring Printers on Windows Devices

      Overview Before you can use printers on Windows, you will have to configure them with your device. 1. Ethernet/LAN Printers A. Star TSP100 Turn printer on. Install the Star driver on PC. Run either the Ethernet Setup Tool or LAN & Bluetooth Setup ...
    • Cash Drawer Troubleshooting

      Overview If your cash drawer is not opening, follow the troubleshooting steps below (depending on if drawer is connected to Ethernet printer or Bluetooth printer).   Troubleshooting for Drawer Connected to Ethernet Printer Make sure your receipt ...
    • eHopper BTP-R180II Printer: Description and Set Up Guide

      Overview This article reviews the features and specifications of the eHopper BTP-R180II Printer and provides all the steps to set it up on your POS. Description of eHopper BTP-R180II Printer Features This cost-effective fully-featured thermal receipt ...